Among the many systems of attachment used for leather watch straps and bands, the following 3 cover 95% of watches :


CLASSICAL ATTACHMENTS :

You can buy the pin tool (instrument for classical spring bars) as well as new pins on this site.

1. Locate the spring inside the watch band.
2. Insert the tool between the ear of the watch and the strap, pressing down on the spring.
3. Lever up to detach the spring bar.
4. Insert the spring bar inside the new strap and reverse the steps above.



FLASH INTERCHANGEABILITY SYSTEM :

We can equip your ABP strap with our interchangeability system. This way, you’ll be able to change your watch straps in a couple of seconds and adapt their colour to your clothes, the seasons, your lifestyle (sports, relation and evening outs) or your moods

1. Turn your watch over (lining face up).
2. Locate the switch along the interchangeable pin.
3. Using your nail, push the switch towards the center.
4. Delicately remove the strap and replace with the new strap in the same fashion.

Always check that the strap is properly attached to the watch by tugging on it gently.



LUG SCREW RELEASE :

You can buy watchmaker’s screwdriver on the site.

1. Position the screw driver in head and loosen (a second screwdriver may be necessary for certain watch models where two screws are holding the pin in place).
2. Once loosened, remove screw release.
3. Strap is now ready for changing. Replace with new strap and tighten screws.